TucsonDataManu

.com

Hyundai Tucson: Body (Interior and Exterior)

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior)

READ NEXT:

 General Information

Troubleshooting Specifications Tightening Torque Special Service Tools

 Fender

Component Location Fender assembly Replacement WARNING When removing the fender, wrap protective tape around a screwdriver or remover not to damage components Put on gloves to prevent hand injuries Remove the front bumper

 Hood

Adjustment After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up and down or from side to side and tighten the bolt. Adjust the hood height by moving the hood overslam bumpers (C) up and down. After loosenin

SEE MORE:

 Transmission Control Module (TCM) Inspection Procedure - Installation

Installation To install, reverse the removal procedure. WARNING The existing O-rings (A) must be replaced with a new one. (Do not reuse it.) Perform the clutch compensation value setting procedure using the diagnostic tool after rep

 Troubleshooting

Trouble Symptom Coolant leakage From the bleed hole of the water pump From gaskets or bolts From outer surface of water pump Probable Cause Visually check Check leaks after about ten-minute warming up. If co

Information