TucsonDataManu

.com

Hyundai Tucson: Rear door outside handle

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Rear Door / Rear door outside handle

Component Location

  1. Rear door outside handle

Replacement

Rear Door Outside Handle Assembly

WARNING

  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Put on gloves to prevent hand injuries.
  1. Remove the plug hole (A).

  1. Loosen the mounting screw (A) and then remove the rear door outside handle (B) by sliding it forward.

Tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

  1. To install, reverse removal procedure.

WARNING

  • Make sure the door locks / unlocks and opens / closes properly.
  • Be sure to install the outside handle pad (A) between the outside handle and the door panel.

    READ NEXT:

     Rear Door Trim - Replacement

    Pull down the rear door window glass to the lowest level by pressing the power window glass switch. Remove the rear door belt outside weatherstrip (A). To install, reverse the removal procedure. WARNING Replace any damaged cli

     Rear door latch

    Component Location Rear door latch Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries. R

     Body Side Molding

    Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries. Remove the roof trim. (Refer to Roof Trim - &

    SEE MORE:

     Wireless Power Charger System

    Description and Operation Wireless Power Charger System During ACC or IG ON, battery voltage is supplied to the wireless power charger system to transmit an output of 5 W to mobile phone. Mobile phones certified with the wireless charging st

     Cylinder Block - Components

    Cylinder block Water jacket insert (Exhaust) Water jacket insert (Intake) Lower crankcase Oil jet O-ring Piston ring (No.1 ring Piston ring (No.2 ring) Piston ring(Oil ring) Piston Piston snap ring

    Information