TucsonDataManu

.com

Hyundai Tucson: Body Side Molding

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Body Side Molding

Replacement

WARNING

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Put on gloves to prevent hand injuries.

Remove the roof trim.
(Refer to Roof Trim - "Roof Trim Assembly")
Loosen the nuts and remove the roof rack assembly (A).

Tightening torque : 9.8 - 15.3 N.m (1.0 - 1.56 kgf.m, 7.2 - 11.3 lb-ft)

To install, reverse the removal procedure.

Rear Spoiler

Component Location Rear Spoiler Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries. Remo

Tailgate back panel

Component Location Tailgate back panel Replacement WARNING Put on gloves to prevent hand injuries. WARNING Take care not to scratch the tailgate and body surface. Remove the tailgate lower trim. (Refer to Tail Gate - "Tail G

Panorama Sunroof

SEE MORE:

Trailer towing

If you are considering towing with your vehicle, be sure to take extra precautions while driving. Only experienced drivers should consider towing. Plan your trip accordingly as vehicle speed limits for vehicles towing trailers may be different.

Transfer Assembly- Installation

To install, reverse the removal procedures. WARNING Be careful not to damage the O-ring (A). If the O-ring is damaged, replace with a new one. Smear and cover splines (B) with molybdenum type high pressure grease. GREASE SPL-1 eq