TucsonDataManu

.com

Hyundai Tucson: Tailgate back panel

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Body Side Molding / Tailgate back panel

Component Location

  1. Tailgate back panel

Replacement

WARNING

Put on gloves to prevent hand injuries.

WARNING

Take care not to scratch the tailgate and body surface.

  1. Remove the tailgate lower trim.

    (Refer to Tail Gate - "Tail Gate Trim")

  2. Using a screwdriver or remover, remove the tailgate back panel (A).

  1. To install, reverse removal procedure.

WARNING

Replace any damaged clips (or pin-type retainers).

    READ NEXT:

     Panorama Sunroof

     Panorama Sunroof - Component

    Mechanism rail assembly Center cover assembly Roller blind motor Glass motor Panorama sunroof frame assembly Roof side molding Decoration cover Movale glass Wind deflecter Front cover assembly Front glass

     Glass step alignment

    Alignment Perform considerable step alignment after replacing movable glass (A). Perfrom height adjustment releasing screw (A) a bit. WARNING Be careful not to damage screws. Remove the decoration cover (A).

    SEE MORE:

     PAB ON/OFF Switch

    Components Location PAB ON/OFF Switch Removal Disconnect the battery negative terminal. WARNING After disconnecting the cables, wait at least 3 minutes. Remove the crash pad side cover. (Refer to Body - "Crash Pad Side C

     Fuses

    A vehicle's electrical system is protected from electrical overload damage by fuses. This vehicle has 5 fuse panels, one located in the driver's side panel bolster, the other in the engine compartment. If any of your vehicle's lights,

    Information