TucsonDataManu

.com

Hyundai Tucson: Windshield Glass - Installtion

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Windshield Glass / Windshield Glass - Installtion

Installtion

  1. Using a knife, scrape the remaining sealant around the body panel leaving about 2mm-thick sealant (0.0079 in.) on the bonding surface. If installing a new windshield glass, make alignment marks on the windshield glass and the body.

WARNING

Be careful not to damage the painted surface of the body.

WARNING

If the surface is damaged, apply paint or rust inhibitor for maintenance.

  1. Clean the edges of body panel and windshield glass with alcohol. Apply glass primer to the edges of windshield glass and attach the molding onto the edges.
  2. Apply the body primer to the bonding surface of body panel.

WARNING

  • Be careful not to touch the surface covered with the primer because touching it may lead to water leaks after installing the windshield glass.
  • Do not apply the body primer to the glass.
  • Remove any foreign materials from the primer-covered surface.

  1. Apply the glass primer to the outer edge of windshield glass.

WARNING

  • Be careful not to touch the surface covered with the primer because touching it may lead to water leaks after installing the windshield glass.
  • Do not apply the body primer to the glass.
  • Remove any foreign materials from the primer-covered surface.
  • Apply the sealant within 5 minutes of applying the primer.

  1. Apply a bead of sealant (B) around the windshield glass (A).

  1. Using the glass holder (A), adjust the windshield glass (B) to fit the alignment marks (C) on the body and lightly push the windshield glass to make the edges fully seated on the bonding surface of body.

  1. Install the windshield glass side garnish (A).

  1. Install the cowl top cover.

    (Refer to "Cowl Top Cover")

  2. Conduct a leak testing.

WARNING

  • Do not directly spray the high-pressure water to the joint area.
  • If driving the car is inevitable, drive at a low speed for at least 8 hours.
  • Advise the driver to avoid aggressive driving or driving on rough roads for 2-3 days after installing the windshield glass.
  1. Install the inside rear view mirror assembly.

    (Refer to Mirror - "Inside Rear View Mirror")

  2. Install the front pillar trim.

    (Refer to Interior Trim - "Front Pillar Trim") (Refer to Interior Trim - "Front Pillar Trim")

    READ NEXT:

     Tail Gate Window Glass

     Tail Gate Window Glass - Removal

    Removal WARNING Put on gloves to prevent hand injuries. WARNING Use seat covers to avoid damaging any surfaces. Remove the tailgate trim. (Refer to Tail Gate - "Tail Gate Trim") Remove the rear spoiler. (Refer to Body Side

     Tail Gate Window Glass - Installtion

    Using a cutting knife (A), remove the remaining sealant (B) on the body panel. Apply the body primer to the bonding surface of body panel. WARNING Be careful not to touch the surface covered with the primer because touching

    SEE MORE:

     Components and Components Location

    Components  Location Engine Control Module (ECM) Mass Air Flow Sensor (MAFS) Manifold Absolute Pressure Sensor (MAPS) Intake Air Temperature Sensor (IATS) Boost Pressure Sensor (BPS) Engine Coolant Temperature Sensor (E

     Front seat belt pretensioner

    Component Location Front seat belt pretensioner Replacement WARNING When installing the belt, make sure not to damage the pretensioner. Disconnect the negative (-) battery terminal. Remove the center pillar upper trim. (Refer to

    Information