TucsonDataManu

.com

Hyundai Tucson: Cowl Top Cover

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Cowl Top Cover

Component Location

  1. Cowl Top Cover

Replacement

  1. Remove the cap and the nuts, and then remove the wiper arm (A).

Tightening torque : 22.6 - 26.5 N.m (2.3 - 2.7 kgf.m, 16.6 - 19.5 lb-ft)

  1. Disconnect the washer nozzle (A).

  1. Loosen the mounting clips, remove the cowl top cover (A).

  1. To install, reverse removal procedure

WARNING

Replace any damaged clips (orpin-type retainers).

    READ NEXT:

     Floor Console

     Floor Console - SBW type

    SBW type Floor console side cover Floor console tray assembly Floor console upper cover assembly Floor console rear mounitng bracket Floor console assembly Component Location SBW type Floor console assembly SBW type - Repla

     Floor Console - SBC type

    SBC type Floor console assembly SBC type WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries. WARNING Tak

    SEE MORE:

     Rear seat back cover - RH

    Remove the rear seat back assembly RH, (Refer to Rear Seat - "Rear Seat Assembly") Loosen the mounting screw, remove the rear seat slide knob (A). Loosen the mounting screws, press the lock pin (B) and remove the rear se

     Windshield Wiper Washer - Installation

    Check the operation of the rain sensor and the light sensor before mounting. Check the sensor for silicon damage. Check w7hether the rain sensor connector is tightened. Check w7hether the rain sensor and bracket are properly tightened.

    Information