TucsonDataManu

.com

Hyundai Tucson: Measuring the resistance of the pressure sensor

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Wheel Drive (4WD) System / Coupling Assembly / Measuring the resistance of the pressure sensor

  1. Turn ignition switch OFF.
  2. Disconnect the pressure sensor connector.
  3. Measure resistance between sensor terminal and terminal.
  4. Check the measured resistance. (Refer to table)

Table 1

Removal

Removal

  1. Remove the coupling assembly.

(Refer to 4 Wheel Drive (4WD) System - "Direct Electro Hydraulic Actuator Coupling")

WARNING

  • Keep it level with the sticker (A) on the top of the coupling.
  1. Remove the pressure sensor (A).

WARNING

  • Keep going horizontal state to prevent leaks during remove the pressure sensor.

Tightening torque: 10.8 - 14.7 N.m (1.1 - 1.5 kgf.m, 8.0 - 10.8 lb-ft)

Installation

Installation

  1. To install, reverse the removal procedure.

WARNING

  • Check the cleanliness of the pressure sensor before installation.
  • Check the pressure sensor O-ring (A).Keep it level with the sticker (A) 011 the top of the coupling.
  • Keep it level with the sticker (A) 011 the top of the coupling.

    READ NEXT:

     Measuring the resistance of the pressure sensor- Adjustment

    Adjustment Description The friction material inside the coupling will degrade over time. Therefore, corresponding compensation values must be referenced and entered after replacing the controller or the coupling. Compensation Requirement and Pr

     General Information

    Trouble shooting Area of leakage occuring/ Area/ Type (1) Connecting part/under part of transfer case (2) Connecting part of transmission/ / A (1) Connecting part/under part of transfer case (2) Connecting part of transmission (

     Transfer Assembly

    SEE MORE:

     ESC Bleeding of Brake System

    This procedure should be followed to ensure adequate bleeding of air and filling of the ESC unit, brake lines and master cylinder with brake fluid. Connect the brake fluid filler to the reservoir tank. WARNING Do not reuse the drained f

     Timing System - Installation

    Install the crankshaft sprocket (A). Place the crankshaft key at the left 180º. Install the oil pump chain. (Refer to Lubrication System - "Oil Pump") Install the timing chain (A). WARNING When in

    Information