Hyundai Tucson: Coupling Assembly
- Coupling Assembly - Description
- Coupling Assembly- Removal
- Coupling Assembly- Installation
- Oil Hydraulic Motor (Actuator) Inspection Procedure
- Measuring the resistance of the pressure sensor
- Measuring the resistance of the pressure sensor- Adjustment
READ NEXT:
Coupling Assembly - Description
Component Location
Coupling assembly
Pressure sensor
Oil hydraulic motor
Description
4\VD ECU processes signals from various sensors and determines the current
road and driving conditions. The ECU then
utilizes this information to
Coupling Assembly- Removal
Inspection
WARNING
All units are filled up with coupling fluid (ultra-low viscosity ATF)
prior to shipping. Inspection, fillup,
and replacement of coupling fluid is therefore not necessary (zero maintenance,
lifetime fluid).
Removal
WARNING
Coupling Assembly- Installation
To install, reverse the removal procedures.
WARNING
Smear the splines (A) with molybdenum type high pressure grease.
When install the coupling, be careful not to damage the oil
seal (B).
After replacing the coupling, reset the 4
SEE MORE:
Piston
Clean the piston.
(1) Using a gasket scraper, remove the carbon from the piston top.
(2) Using a groove cleaning tool or broken ring, clean the piston ring grooves.
(3) Using solvent and a brush, thoroughly clean the piston.
WARNING
Do
Piston Pin - Reassembly
WARNING
Thoroughly clean all parts to assembled.
Before installing the parts, apply fresh engine oil to all
sliding and rotating surfaces.
Always use new gaskets, O-ring and oil seals.
Install the crankshaft position sensor wheel
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
