Hyundai Tucson: Wheel Drive (4WD) System
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Wheel Drive (4WD) System
- Coupling Assembly
- Coupling Assembly - Description
- Coupling Assembly- Removal
- Coupling Assembly- Installation
- Oil Hydraulic Motor (Actuator) Inspection Procedure
- Measuring the resistance of the pressure sensor
- Measuring the resistance of the pressure sensor- Adjustment
- General Information
- Transfer Assembly
READ NEXT:
Coupling Assembly - Description
Component Location
Coupling assembly
Pressure sensor
Oil hydraulic motor
Description
4\VD ECU processes signals from various sensors and determines the current
road and driving conditions. The ECU then
utilizes this information to
Coupling Assembly- Removal
Inspection
WARNING
All units are filled up with coupling fluid (ultra-low viscosity ATF)
prior to shipping. Inspection, fillup,
and replacement of coupling fluid is therefore not necessary (zero maintenance,
lifetime fluid).
Removal
WARNING
SEE MORE:
Blind-Spot Collision-Avoidance Assist (BCA)
BCA activating conditions
(1) User Setting Menu (USM): Select 'Driver Assistance' -> 'Blind-Spot Safety' -- 'Blind-Spot Collision-Avoidance-Assist'
(2) Vehicle speed: 60 kmh - 200 km h
(3) Curvature radius: 600m or more
(4) Both lanes
Oil Pump Chain
Disconnect the battery negative terminal.
Remove the timing chain.
(Refer to Timing System - "Timing Chain")
Remove the oil pump chain tensioner (A).
Tightening torque :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
