TucsonDataManu

.com

Hyundai Tucson: Driveshaft side oil seal #3 B Typel

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Wheel Drive (4WD) System / Transfer Assembly / Driveshaft side oil seal #3 B Typel

  1. Remove the transfer assembly.

(Refer to 4 Wheel Drive (4WD) System - "Front Wheel Transfer Assembly")

  1. Remove the dust cover (A).

  1. Remove the oil seal #2 (A).

  1. Remove the oil seal #3 (A).

  1. Install the oil seal #3 (A) with a new one by using the special service tools (0K473-P2300, 09231- H1100).

  1. Install the oil seal #2 (A) with a new one by using the special service tools (0K473-P2200, 09231- H1100).

  1. Remove the special service tools
  2. Install the dust cover (A) with a new one.

  1. Install the transfer assembly.

(Refer to 4 Wheel Drive (4WD) System - "Front Wheel Transfer Assembly")

  1. If the transfer oil is leaking, add the transfer with oil.

(Refer to 4 Wheel Drive System - "Transfer Fluid")

Transaxle side oil seal B Type

  1. Remove the transfer assembly.

(Refer to 4 Wheel Drive (4WD) System - "Front Wheel Transfer Assembly")

  1. Remove the transfer assembly side oil seal (A).

  1. Install the oil seal with a new one by using the special service tools (0K473-P2400, 09231-H1100).

  1. Remove the special service tools
  2. Install the transfer assembly.

(Refer to 4 Wheel Drive (4WD) System - "Front Wheel Transfer Assembly")

  1. If the transfer oil is leaking, add the transfer with oil.

(Refer to 4 Wheel Drive System - "Transfer Fluid")

    READ NEXT:

     Driveshaft and axle

     Front Axle Assembly

    Components Front brake disc Front hub assembly Dust cover Front knuckle Removal WARNING When lifting a vehicle using a lift, be careful not to damage the lower parts of the vehicle (floor under cover, fuel filter, fuel tank

     Driveshaft Assembly

    SEE MORE:

     Rear Brake Disc

    Rear Brake Disc  Thickness Check Inspection Check the brake disc for damage and cracks. Remove all rust and contamination from the surface, and measure the disc thickness at 24 points, at least, of same distance (5mm) from the brake

     Reverse Parking Collision- Avoidance Assist Operation

    Operating conditions If 'Rear Active Assist' or 'Rear Warning Only' is set from the Settings menu, Reverse Parking Collision-Avoidance Assist will be in the ready status when the following conditions are satisfied: The liftgate is closed T

    Information