TucsonDataManu

.com

Hyundai Tucson: Transfer Assembly

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Wheel Drive (4WD) System / Transfer Assembly

Transfer Assembly- Inspection

Inspection Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover") Loosen the oil filler plug (A). A Type B Type Check the oil level. WARNING Oil level must be up to fil

Transfer Assembly- Removal

Removal A Type Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover") Remove the front driveshaft assembly. Right side (Refer to Driveshaft and Axle - "Front Driveshaft")

Transfer Assembly- Installation

To install, reverse the removal procedures. WARNING Be careful not to damage the O-ring (A). If the O-ring is damaged, replace with a new one. Smear and cover splines (B) with molybdenum type high pressure grease. GREASE SPL-1 eq

SEE MORE:

Engine Oil

Check the engine oil quality. Check the oil deterioration, entry of water, discoloring of thinning. If the quality is visibly poor, replace the oil. Check the engine oil level. After warning up the engine and then 10 minutes after the

Charge and Retest method after battery charge

Battery charge Set battery charger to 'Auto Mode' (The Mode that charging current drops as the battery charges.) and charge battery until charging current down close to zero or the charger alerts you with an alarm when charge is complete.(Mini