Hyundai Tucson: DCT (Dual Clutch Transmission) System (SBC) - Description
Description
The Dual Clutch Transmission (DCT) control system measures required data to identify the state of the control target and computes the appropriate compensation value if adjustment is necessary. The actuator is controlled according to the computed compensation value to obtain desired output.
If transmission or driving-performance-related failure is detected, first perform self-diagnosis and basic transmission inspection (oil check).
Then use the diagnostic tool to inspect the transmission control system components.
Operation principle
Description
Function
The Transmission Control Module (TCM) is like the brain for the Dual Clutch Transmission (DCT). It receives information from various sensors for a wide range of transmission controls to provide an optimal driving environment for the driver. The TCM is programmed for optimal operation in all driving conditions. If the TCM malfunctions, store the failure information in memory and provide the error information to a mechanic for fast and accurate repair.
Components
- Fork cover
- Clutch actuator & TCM assembly
- Clutch actuator assembly
- O-ring
- DCT control module (TCM)
Connector and Terminal Function
READ NEXT:
Transmission Control Module (TCM) Inspection Procedure
Inspection
Inspecting TCM ground circuit: Measure the resistance between the TCM
and chassis ground.
(Check the terminal connected to the chassis ground while using the back of
the harness connector as the base point for TCM.)
Normal
Transmission Control Module (TCM) Inspection Procedure - Installation
Installation
To install, reverse the removal procedure.
WARNING
The existing O-rings (A) must be replaced with a new one. (Do not
reuse it.)
Perform the clutch compensation value setting procedure using the
diagnostic tool after rep
The DCT system
Components
Fork cover
Clutch actuator & TCM assembly
Clutch actuator assembly
O-ring
DCT control module (TCM)
Specification
Inspection
The DCT system can be more quickly diagnosed for troubles by using the
vehicle diagn
SEE MORE:
Idle Stop and Go (ISG)
Idle Stop and Go helps reduce fuel
consumption by automatically shutting
down the engine, when the vehicle is
at a standstill (i.e. red stop light, stop
sign, and traffic jam) subject to certain
prerequisite conditions being satisfied as
listed
Glass Adjustment
WARNING
Check the glass run channel for damage or deterioration, and replace
it if necessary.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
Lower the glass by operating the power window switch until the gl
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
