Hyundai Tucson: DCT (Dual Clutch Transmission) System
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / DCT (Dual Clutch Transmission) System
- General Information
- DCT (Dual Clutch Transmission) System (SBC)
- DCT (Dual Clutch Transmission) System (SBC) - Removal
- DCT (Dual Clutch Transmission) System (SBC) - Installation
- DCT (Dual Clutch Transmission) System (SBC) - Inspection
- DCT (Dual Clutch Transmission) System (SBC) - Replacement
- DCT (Dual Clutch Transmission) System (SBC) - Description
- Transmission Control Module (TCM) Inspection Procedure
- Transmission Control Module (TCM) Inspection Procedure - Installation
- The DCT system
- The DCT system- Installation
- The DCT system-Adjustment
- Gear acmator assembly
- Gear acmator assembly- Description
- Inhibitor switch/ Manual control lever
- Inhibitor switch/ Manual control lever- Removal
- Shift lever knob & boots assembly
- Shift gear
- Dual clutch assembly
- Engagement bearing - Components
- DCT (Dual Clutch Transmission) System (SBW)
- DCT (Dual Clutch Transmission) System (SBW)- Removal
- DCT (Dual Clutch Transmission) System (SBW)- Installation
- DCT (Dual Clutch Transmission) System (SBW)- Inspection
- Clutch Actuator & TCM- Assembly Replacement
- Transmission Control Module (TCM) Inspection Procedure
- Clutch actuator assembly - Components
- Gear actuator assembly
- Gear actuator assembly- Installation
- Input shaft speed sensor
- Input shaft speed sensor- Removal
- Input shaft speed sensor- Installation
- Clutch fork and clutch bearing
READ NEXT:
General Information
Troubleshooting
Specifications
Dual clutch transmission
Clutch actuator
Gear actuator
Inhibitor Switch
Input speed sensor
Tightening Torques
Lubricants
Special Service Tools
Tool
(Number and
Nam
DCT (Dual Clutch Transmission) System (SBC) - Removal
Removal
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
Remove the ECM.
(Refer to Engine Control / Fue
SEE MORE:
Transmission Control Module (TCM) Inspection Procedure - Installation
Installation
To install, reverse the removal procedure.
WARNING
The existing O-rings (A) must be replaced with a new one. (Do not
reuse it.)
Perform the clutch compensation value setting procedure using the
diagnostic tool after rep
The DCT system-Adjustment
Adjustment
WARNING
If you replaced the dual clutch assembly or clutch actuator, be
sure to perform wear compensation by referring to the
following table.
If the rod length is less than 52 mm (2.0472 in.), replace all
of the dual cl
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
