Hyundai Tucson: General Information
Troubleshooting
Specifications
Dual clutch transmission
Clutch actuator
Gear actuator
Inhibitor Switch
Input speed sensor
Tightening Torques
Lubricants
Special Service Tools
Tool (Number and Name)/ Illustration/ Use
09200-3N000
Engine
support fixture
(Beam)/ 
/ Removal and
installation of the
transmission.
Use this beam (SSTNo. : 09200- 3N000) with the supporter (SST No. : 09200- 2S200).
09200-2S200
Engine
support fixture
(Supporter)/ 
/ Removal and
installation of the
transaxle.
with the beam (SSTNo. : 09200- 38001/3N000).
09200-L1200
Engine
support fixture
(Front)/ 
/ Removal and
installation of the
transaxle.
with the beam (SSTNo. : 09200- 38001/3N000).
09200-4X000
Engine
support fixture
(Adapter)/ 
/ Removal and
installation of the
transaxle.
Use this beam (SST No. : 09200- 3N000)
Oil seal
installer
09453-3L240/ 
/ Used for installing
differential oil seal
Used with the
handle (09231-
H1100)
09473-D3500
Oil seal
installer/ 
/ Used for installing
driven gear oil seal
Used with the
handle (09231-
H1100)
4WD
Handle
09231-H1100/ 
/ Used for installing
differential oil seal
Used with the
installer (09453-
3L240)
Inhibitor
switch guide
pin
09480-A3800/ 
/ Used for fixing "N"
range when
installing inhibitor
switch
Dual clutch
remover
09430-C1180/ 
/ Used for removing
dual clutch
assembly
Dual clutch
installer
09430-2A240/ 
/ Used for installing
dual clutch
assembly
Clutch
actuator
remover &
installer
0K430-Q5100/ 
/ Removal and
installation of the
clutch actuator
assembly.
Clutch
actuator
adjuster
0K430-Q5300/ 
/ Used for adjusting
clutch actuator
Components
- DC'T (Dual Clutch Transmission) assembly
- DC'T support bracket
- Roll rod support bracket
READ NEXT:
DCT (Dual Clutch Transmission) System (SBC) - Removal
Removal
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
Remove the ECM.
(Refer to Engine Control / Fue
DCT (Dual Clutch Transmission) System (SBC) - Installation
Installation
To install, reverse the removal procedure.
WARNING
Matters that require attention when installing the dual clutch
transmission (DCT) to engine
l)Check the pilot bearing (B) and external damper (A) on the side of
engine for a
SEE MORE:
Rear Driveshaft Assembly - Disassembly
Disassembly
WARNING
Do not disassemble the BJ assembly.
Special grease must be applied to the driveshaft joint. Do not
substitute with another type of grease.
The boot band should be replaced with a new one.
Remove the TJ boot bands
RCV Control Solenoid Valve
Description
RCV (Recirculation Valve) Control Solenoid Valve is installed on the
intercooler inlet pipe and
operates the RCV actuator which controls the by-pass passage of the turbocharger
compressor.When
the throttle is closed, while the engi
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
