TucsonDataManu

.com

Hyundai Tucson: Engine And Transaxle Assembly - Removal and Installation

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Mechanical System / Engine And Transaxle Assembly / Engine And Transaxle Assembly - Removal and Installation

  1. Remove the engine cover (A).

  1. Installation is reverse order of removal

Removal and Installation

Front Under Cover

  1. Remove the engine room under cover (A).

Tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

  1. Installation is reverse order of removal.

Rear Under Cover

  1. Remove the engine room rear under cover (A).

Tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

  1. Installation is reverse order of removal.

Components

  1. Engine mounting support bracket
  2. Engine mounting bracket
  3. Transaxle mounting bracket
  4. Roll road bracket

    READ NEXT:

     Engine mounting bracket

    Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") Install the jack to the edge of oil pan. WARNING Insert the rubber block between jack and oil pan. Remove the eng

     Transaxle mounting bracket

    Disconnect the negative battery terminal. Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") Remove the air duct and air cleaner assembly. (Refer to Intake and Exhaust Sys

     Roll rod bracket

    Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") Remove the roll rod bracket (A). Tightening torque : Bolt (B): 107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)

    SEE MORE:

     Rear Outside Combination Lamp

    Disconnect the negative (-) battery terminal. Loosen the mounting bolts then remove the outside rear combination lamp (A). Disconnect the rear combination lamp connector (A). Remove the bulb after turning it in the counter

     The DCT system-Adjustment

    Adjustment WARNING If you replaced the dual clutch assembly or clutch actuator, be sure to perform wear compensation by referring to the following table. If the rod length is less than 52 mm (2.0472 in.), replace all of the dual cl

    Information