Hyundai Tucson: Engine And Transaxle Assembly
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Mechanical System / Engine And Transaxle Assembly
- Engine And Transaxle Assembly - Removal and Installation
- Engine mounting bracket
- Transaxle mounting bracket
- Roll rod bracket
READ NEXT:
Engine And Transaxle Assembly - Removal and Installation
Remove the engine cover (A).
Installation is reverse order of removal
Removal and
Installation
Front Under Cover
Remove the engine room under cover (A).
Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
Engine mounting bracket
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
Install the jack to the edge of oil pan.
WARNING
Insert the rubber block between jack and oil pan.
Remove the eng
Transaxle mounting bracket
Disconnect the negative battery terminal.
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
Remove the air duct and air cleaner assembly.
(Refer to Intake and Exhaust Sys
SEE MORE:
Windows
Driver's door power window switch
Front passenger's door power
window switch
Rear door (left) power window switch
Rear door (right) power window
switch
Window opening and closing
Automatic power window*
Power window lock switch
When Ignition Key Is Turned ON (engine OFF), The ABS Warning Lamp Does Not
Light Up.
Detecting condition
When current flows in the HECU the ABS warning lamp turns from ON
to OFF as the initial check. Therefore if the lamp does not light up. the
cause may be an open in the lamp power supply circuit, a blown bulb, an
open in the bo
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
