Hyundai Tucson: Transmission Control Module (TCM) Inspection Procedure - Installation
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / DCT (Dual Clutch Transmission) System / DCT (Dual Clutch Transmission) System (SBC) / Transmission Control Module (TCM) Inspection Procedure - Installation
Installation
- To install, reverse the removal procedure.
WARNING
The existing O-rings (A) must be replaced with a new one. (Do not
reuse it.) 
- Perform the clutch compensation value setting procedure using the diagnostic tool after replacing TCM.
WARNING
- Before performing the DCT learning procedure using diagnostic tool, perform the learning process after leaving for 5 minutes in the idle state. Because it may be a problem to operation of wear compensation device when entering the DCT learning function at battery low voltage condition.
- When performing the DCT learning function, Perform the DCT learning function twice to ensure accuracy and reliability of the clutch touch point.
- When the ignition is turned off after completing the 2 steps of the DCT learning procedure, the operation of wear compensation device will be performed. It takes up to 6 minutes for the operation of the wear compensation device to be completed, during which time it should not be started engine.
- The engine must be started after at least 6 minutes to ensure that the wear compensation device is fully operated, (keep the engine off for at least 6 minutes)
- If the engine is started while the wear compensation device is operating, sufficient operation of the wear compensation device is not possible, so the excessive operation of the wear compensation device may occur in the next engine starting cycle
- Perform the clutch touch point learning procedure using the diagnostic tool after replacing TCM
READ NEXT:
The DCT system
Components
Fork cover
Clutch actuator & TCM assembly
Clutch actuator assembly
O-ring
DCT control module (TCM)
Specification
Inspection
The DCT system can be more quickly diagnosed for troubles by using the
vehicle diagn
The DCT system- Installation
Installation
To install, reverse the removal procedures.
Check the assembled state of the dowel pins (A) before installing the
clutch acmator assembly.
Perform the clutch touch point learning procedure using the diagnostic
tool.
The DCT system-Adjustment
Adjustment
WARNING
If you replaced the dual clutch assembly or clutch actuator, be
sure to perform wear compensation by referring to the
following table.
If the rod length is less than 52 mm (2.0472 in.), replace all
of the dual cl
SEE MORE:
Infotainment system
NOTICE
If you install an aftermarket HID
head lamp, your vehicle's audio and
electronic devices may not function
properly.
Prevent chemicals such as perfume,
cosmetic oil, sun cream, hand
cleaner, and air freshener from
contacting t
Manual heating and air conditioning
Start the engine.
Set the mode to the desired position.
For improving the effectiveness of
heating and cooling, select:
Heating:
Cooling:
Set the temperature control to the
desired position.
Set the air intake contr
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
