Hyundai Tucson: Intelligent Manaul Transaxle Type
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Disconnect the ignition lock & clutch switch connector (A).
- Loosen the bolts (A) and then removing the ignition lock & clutch switch (B).
Tightening torque : 2.5 - 3.5 N.m (0.25 - 0.35 kgf.m, 18.1 - 25.3 lb-ft)
Installation
- Install is proceds as follows.
* How to install the ignition lock & clutch switch
(A) After inserting the switch lever (A) into the clutch pedal pin (B). pre-tighten the switch mounting bolt (C).
(B) Set the clutch switches so as to confirm that the electric current is applied to the pins(2) to (4).
- Set the clutch switches so as to confirm that the electric current is applied to the pins (1) to (3).
(C) Fix the clutch pedal to the ignition lock switch OFF/ON strokes (F).
(D) With the pedal fixed, rotate the switch clockwise and counter-clockwise to set it to a position at the transition from OFF to ON. Then, tighten the mounting bolt (C) to the specified torque.
(E) Once completing the assembly, check again that the switch is correctly operating.
Tightening torque : Ignition lock & clutch switch mounting bolts (C): 2.5 - 3.5 N.m (0.25 - 0.35 kgf.m, 18.1 - 25.3 lb-ft)
Ignition lock switch
Clutch switch
READ NEXT:
Clutch Pedal Stroke Sensor
Removal
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the clutch pedal stroke sensor connector (A).
Loosen the bolts (A) and then removing the clutch pedal stroke sensor
(B).
Installation
Clutch Pedal
Components
Manual Transaxle Type
Clutch pedal arm
Clutch master cylinder
Clutch pedal assembly
Intelligent Manaul Transaxle Type
Ignition lock & clutch switch
Clutch pedal stroke sensor
Clutch pedal assembly
Removal
Clutch Tube
Components and Components Location
Clutch pedal arm
Clutch pedal assembly
Reservoir hose
Regulator
Cluch tube
Clutch hose
Removal
Remove the air cleaner assembly and air duct.
(Refer to In case by Gasoline 1.6 T-GDI System
SEE MORE:
Crankshaft Position Sensor (CKPS)
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one
of the most important
sensors of the engine control system. If there is no CKPS signal input, fuel is
not supplied.That is,
vehicle can't run without
Variable Force Solenoid (VFS)
Description
CVVT (Continuous Variable Valve Timing) system advances or retards the valve
opening and closing
timing of the intake or the exhaust valve in accordance with the ECM control,
calculated by the engine
speed and the load. The CVVT co
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual