TucsonDataManu

.com

Hyundai Tucson: Clutch Tube

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Clutch System / Clutch Tube

Components and Components Location

  1. Clutch pedal arm
  2. Clutch pedal assembly
  3. Reservoir hose
  4. Regulator
  5. Cluch tube
  6. Clutch hose

Removal

  1. Remove the air cleaner assembly and air duct.

(Refer to In case by Gasoline 1.6 T-GDI System - "Air Cleaner")

(Refer to In case by Diesel 1.6 TCI System - "Air Cleaner")

(Refer to In case by Gasolione 2.0 MPI System - "Air Cleaner")

  1. Remove the battery and batteiy tray.

(Refer to In case by Gasoline 1.6 T-GDI System - "Battery")

(Refer to In case by Diesel 1.6 TCI System - "Battery")

(Refer to In case by Gasoline 2.0 MPI System - "Battery")

  1. Pull the snap pin (A) and then separate the clutch tube (B).

  • Do not spill brake fluid on the vehicle it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
  1. Remove the snap pin (A) and then separate the clutch hose (B).

Gasoline 1.6 T-GDI

Diesel 1.6 TCI

Diesel 1.6 TCI

  1. Separate the clips (A, B) and then removing the clutch hose & tube from the vehicle.

Installation

Installation

  1. To install, reverse the removal procedures.
  2. Perform bleeding air procedure in concentric slave cylinder after pouring the brake fluid.

(Refer to Clutch System - "Concentric Slave Cylinder Assembly")

    READ NEXT:

     Clutch Regulator

    Components and Components Location Clutch pedal arm Clutch pedal assembly Reservoir hose Regulator Cluch tube Clutch hose Removal Remove the air cleaner assembly and air duct. (Refer to In case by Gasoline 1.6 T-GDI System

     Clutch Master Cylinder

    Components Clutch pedal arm Clutch master cylinder Clutch pedal assembly Removal Remove the clutch pedal. (Refer to Clutch System - "Clutch Pedal") Remove the clip (A). Remove the push rod pin (A) by push

      Concentric Slave Cylinder Assembly

    SEE MORE:

     Charge and Retest method after battery charge

    Battery charge Set battery charger to 'Auto Mode' (The Mode that charging current drops as the battery charges.) and charge battery until charging current down close to zero or the charger alerts you with an alarm when charge is complete.(Mini

     Cylinder Head - Installation

    WARNING Thoroughly clean all parts to be assembled. Always use a new cylinder head gasket and manifold gasket. Always use a new cylinder head bolt and cylinder head bolt washer. The cylinder head and exhaust manifold is a metal gasket. T

    Information

    2022-2026 © - www.tucsondatamanu.com