TucsonDataManu

.com

Hyundai Tucson: Clutch Master Cylinder

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Clutch System / Clutch Master Cylinder

Components

Clutch pedal arm
Clutch master cylinder
Clutch pedal assembly

Removal

Remove the clutch pedal.

(Refer to Clutch System - "Clutch Pedal")

Remove the clip (A).

Remove the push rod pin (A) by pushing it in the "F" direction.

Loosen the bolts (A) and then removing the clutch master cylinder (B).

Installation

Installation

To install, reverse the removal procedures.
Perform bleeding air procedure in concecntric slave cylinder after pouring the brake fluid.

(Refer to Clutch Svstem - "Concentric Slave Cylinder Assembly"

Concentric Slave Cylinder Assembly

Concentric Slave Cylinder Assembly - Removal

Gasoline 1.6 T-GDI / Gasoline 2.0 MPI Remove the manual transaxle assembly. (Refer to In case by Gasoline 1.6 T-GDI System - "Manual Transaxle") (Refer to In case by Gasoline 1.6 T-GDI System - "Intelligent Manual Transaxle&q

Concentric Slave Cylinder Assembly- Installation

Manual Transaxle Type To install, reverse the removal procedures. WARNING Install the concentric slave cylinder bolts. Not to be bent or twisted, Tighten them in diagonal directions. Cup. Inner surface of body and outer surface of tub

SEE MORE:

Cruise Control System (CC) - Description

Description The cruise control system is engaged by the cruise "ON/OFF" main switch located on right of steering wheel column. The system has the capability to cruise, coast, accelerate and resume speed. It also has a safety interr

Differential Carrier Assembly - Reassembly

Reassembly Pinion drive gear assembly Install the inner pinion bearing adjustment shim (A) 011 the pinion drive gear assembly. Install the inner pinion bearing (A) on the pinion drive gear using SST (0K530-P2200) and press.