TucsonDataManu

.com

Hyundai Tucson: Concentric Slave Cylinder Assembly

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Clutch System / Concentric Slave Cylinder Assembly

Concentric Slave Cylinder Assembly - Removal

Gasoline 1.6 T-GDI / Gasoline 2.0 MPI Remove the manual transaxle assembly. (Refer to In case by Gasoline 1.6 T-GDI System - "Manual Transaxle") (Refer to In case by Gasoline 1.6 T-GDI System - "Intelligent Manual Transaxle&q

Concentric Slave Cylinder Assembly- Installation

Manual Transaxle Type To install, reverse the removal procedures. WARNING Install the concentric slave cylinder bolts. Not to be bent or twisted, Tighten them in diagonal directions. Cup. Inner surface of body and outer surface of tub

Concentric Slave Cylinder Assembly- Adjustment

Gasoline 1.6 T-GDI Turn ignition switch OFF and disconnect the negative (-) battery cable. Remove the air cleaner assembly and air duct. (Refer to In case by Gasoline 1.6 T-GDI System - "Air Cleaner") After disconnecting a cap

SEE MORE:

Front Door - Replacement

Remove the outside rear view mirror. (Refer to Mirror - "Outside Rear View Mirror") Remove the front door belt outside weatherstrip (A). To install, reverse the removal procedure. WARNING Replace any damaged clips (or p

DCT (Dual Clutch Transmission) System (SBC) - Installation

Installation To install, reverse the removal procedure. WARNING Matters that require attention when installing the dual clutch transmission (DCT) to engine l)Check the pilot bearing (B) and external damper (A) on the side of engine for a