Hyundai Tucson: Concentric Slave Cylinder Assembly - Removal
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Clutch System / Concentric Slave Cylinder Assembly / Concentric Slave Cylinder Assembly - Removal
Gasoline 1.6 T-GDI / Gasoline 2.0 MPI
- Remove the manual transaxle assembly.
(Refer to In case by Gasoline 1.6 T-GDI System - "Manual Transaxle")
(Refer to In case by Gasoline 1.6 T-GDI System - "Intelligent Manual Transaxle")
(Refer to In case by Gasoline 2.0 MPI System - "Manual Transaxle")
- Pull the clip (A). In case by Intelligent Manual Transaxle type
- Loosen the bolts and then removing the concentric slave cylinder (A).
Tightening torque : 19.6 - 26.5 N.m (2.0 - 2.7 kgf.m, 14.2 - 19.5 lb-fit)
Diesel 1.6 TCI
- Remove the manual transaxle assembly.
(Refer to In case by Diesel 1.6 TCI System - "Manual Transaxle")
(Refer to In case by Diesel 1.6 TCI System - "Intelligent Manual Transaxle")
- Pull the clip (A). In case by Intelligent Manual Transaxle type
- Remove the concentric slave cylinder assembly from the transaxle case by loosening the bolts (A).
Tightening torque : 19.6 - 26.5 N.m (2.0 - 2.7 kgf.m, 14.2 - 19.5 lb-fit)
READ NEXT:
Concentric Slave Cylinder Assembly- Installation
Manual Transaxle Type
To install, reverse the removal procedures.
WARNING
Install the concentric slave cylinder bolts. Not to be bent or
twisted, Tighten them in diagonal directions.
Cup. Inner surface of body and outer surface of tub
Concentric Slave Cylinder Assembly- Adjustment
Gasoline 1.6 T-GDI
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the air cleaner assembly and air duct.
(Refer to In case by Gasoline 1.6 T-GDI System - "Air Cleaner")
After disconnecting a cap
SEE MORE:
High Pressure Fuel Line- Installation
Install in the reverse order of removal.
Install the high pressure fuel pipe as follows.
(1) Completely pre-tighten the both side nuts (A) on high pressure tightening
area of high pressure fuel pipe
while keeping them vertically.
(2) Ti
Components and Components Location
Components Location
Engine Control Module (ECM)
Mass Air Flow Sensor (MAFS)
Manifold Absolute Pressure Sensor (MAPS)
Intake Air Temperature Sensor (IATS)
Boost Pressure Sensor (BPS)
Engine Coolant Temperature Sensor (E
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
