Hyundai Tucson: Inside rear view mirror
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Mirror / Inside rear view mirror
Component Location
- Inside rear view mirror
Replacement
WARNING
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- Put on gloves to prevent hand injuries.
- Disconnect the negative (-) battery terminal.
- Remove the inside rear view mirror cover (A).
- Remove the rain sensor cover (A).
- Disconnect the inside rear view mirror connector (A).
- Loosen the mounted screws and push the ECM mirror base upward to remove the ECM mirror assembly (A).
- To install, reverse removal procedure.
WARNING
Be careful not to damage the windshield glass.
WARNING
Make sure the connector is connected properly.
READ NEXT:
Cowl Top Cover
Component Location
Cowl Top Cover
Replacement
Remove the cap and the nuts, and then remove the wiper arm (A).
Tightening torque :
22.6 - 26.5 N.m (2.3 - 2.7 kgf.m, 16.6 - 19.5 lb-ft)
Disconnect the washer nozzle (A).
Floor Console - SBW type
SBW type
Floor console side cover
Floor console tray assembly
Floor console upper cover assembly
Floor console rear mounitng bracket
Floor console assembly
Component Location
SBW type
Floor console assembly
SBW type - Repla
SEE MORE:
Hood
Adjustment
After loosening the hinge (A) mounting bolt, adjust the hood (B) by
moving it up and down or from side to side and tighten
the bolt.
Adjust the hood height by moving the hood overslam bumpers (C) up and
down.
After loosenin
GPF Regeneration- Description
Description
Continuous Variable Valve Timing (CVVT) system advances or retards the valve
timing of the intake and exhaust valve in accordance with the ECM control signal
which is calculated by the engine speed and load.
By controlling CVVT, th
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
