Hyundai Tucson: Clutch Pedal

Components

Manual Transaxle Type

1. Clutch pedal arm
2. Clutch master cylinder
3. Clutch pedal assembly

Intelligent Manaul Transaxle Type

1. Ignition lock & clutch switch
2. Clutch pedal stroke sensor
3. Clutch pedal assembly

Removal

Manaul Transaxle Type

1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
2. Remove the air cleaner assembly and air duct.

(Refer to In case by Gasoline 1.6 T-GDI System - "Air Cleaner")

(Refer to In case by Diesel 1.6 TCI System - "Air Cleaner")

(Refer to In case by Gasolione 2.0 MPI System - "Air Cleaner")

3. Remove the battery and battery tray.

(Refer to In case by Gasoline 1.6 T-GDI System - "Battery")

(Refer to In case by Diesel 1.6 TCI System - "Battery")

(Refer to In case by Gasoline 2.0 MPI System - "Battery")

4. Pull the snap pin (A) and then separate the clutch regulator (B).
5. Separate the reservoir hose (C).

6. Disconnect the ignition lock & clutch switch connector (A).

7. Loosen the nuts (A) and then removing the clutch pedal.

Tightening torque : 16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 Ib-ft)

Intelligent Manaul Transaxle Type

8. Turn ignition switch OFF and disconnect the negative (-) battery cable.
9. Disconnect the ignition lock & clutch switch (A) and clutch pedal stroke sensor connector (B).

10. Loosen the nuts and then removing the clutch pedal (A).

Tightening torque : 16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 Ib-ft)

Installation

1. To install, reverse the removal procedures.
2. Perform bleeding air procedure in concentric slave cylinder after pouring the brake fluid.

(Refer to Clutch System - "Concentric Slave Cylinder Assembly")

READ NEXT: