Hyundai Tucson: Ignition Lock & Clutch Switch
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Clutch System / Ignition Lock & Clutch Switch
READ NEXT:
Ignition Lock & Clutch Switch - Description
Description
Clutch operation is detected through clutch switch signal. This signal
enables ECM to cope with
instant change of load condition.
Clutch switch signal is used to detect engaged gear with vehicle speed
and engine speed.
Co
Intelligent Manaul Transaxle Type
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the ignition lock & clutch switch connector (A).
Loosen the bolts (A) and then removing the ignition lock & clutch switch
(B).
Tightening
Clutch Pedal Stroke Sensor
Removal
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the clutch pedal stroke sensor connector (A).
Loosen the bolts (A) and then removing the clutch pedal stroke sensor
(B).
Installation
SEE MORE:
Brake Pedal - Removal
Turn ignition switch OFF and disconnect the negative (-) batteiy cable.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
Disconnect the stop lamp switch connector (A).
Pull the locking plate (A)
Troubleshooting
Problem Symptoms Table
Use the table below to help you find the cause of the problem. The numbers
indicate the priority of the
likely cause of the problem.
Check each part in order.
If necessary, replace these parts.
Specificat
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
