Hyundai Tucson: Clutch Pedal Stroke Sensor
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Clutch System / Clutch Pedal Stroke Sensor
Removal
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Disconnect the clutch pedal stroke sensor connector (A).

- Loosen the bolts (A) and then removing the clutch pedal stroke sensor (B).

Installation
- To install, reverse the removal procedures.
READ NEXT:
Clutch Pedal
Components
Manual Transaxle Type
Clutch pedal arm
Clutch master cylinder
Clutch pedal assembly
Intelligent Manaul Transaxle Type
Ignition lock & clutch switch
Clutch pedal stroke sensor
Clutch pedal assembly
Removal
Clutch Tube
Components and Components Location
Clutch pedal arm
Clutch pedal assembly
Reservoir hose
Regulator
Cluch tube
Clutch hose
Removal
Remove the air cleaner assembly and air duct.
(Refer to In case by Gasoline 1.6 T-GDI System
Clutch Regulator
Components and Components Location
Clutch pedal arm
Clutch pedal assembly
Reservoir hose
Regulator
Cluch tube
Clutch hose
Removal
Remove the air cleaner assembly and air duct.
(Refer to In case by Gasoline 1.6 T-GDI System
SEE MORE:
Engine oil
Checking the engine oil level
Engine oil is used for lubricating,
cooling, and operating various hydraulic
components in the engine. Engine oil
consumption while driving is normal,
and it is necessary to check and refill the
engine oil regularl
General Information
Troubleshooting
Specifications
Tightening torque
Special Service
Tools
Tool
(Number and
Name)/
Illustration/ Use
09568-1S100
Ball joint
remover/ / Removal of
the tie rod
end ball
joint.
09568-4R100
Lower arm
ball j
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual