Hyundai Tucson: Driveshaft Assembly
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Driveshaft and axle / Driveshaft Assembly
READ NEXT:
Driveshaft Assembly- Removal
Components
Front driveshaft (LH)
Inner shaft bearing bracket
Front driveshaft (RH)
Removal
WARNING
When lifting a vehicle using a lift, be careful not to damage
the lower parts of the vehicle (floor under cover,
fuel filter,
Driveshaft Assembly- Installation
Installation
To install, reverse the removal procedures.
Check the alignment.
(Refer to Suspension System - "Alingment")
Removal
Remove the front drive shaft.
(Refer to Driveshaft Assembly - "Front Driveshaft")
Driveshaft Assembly- Inspection
Check the boot for water or foreign objects.
Replace any defective parts.
Installation
The type can replace the wheel side joint boot
WARNING
When assembling, be careful not to let dust and foreign
substances enter.
Driveshaft join
SEE MORE:
Ignition Lock & Clutch Switch - Description
Description
Clutch operation is detected through clutch switch signal. This signal
enables ECM to cope with
instant change of load condition.
Clutch switch signal is used to detect engaged gear with vehicle speed
and engine speed.
Co
Steering wheel - Disassembly
Disassembly
Loosen the paddle shift switch mounting screw (A).
Remove the paddle shift switch (A) after disconnecting the connector.
Remove the lower cover (A) after loosening the screw.
Disconnect the wiring
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
