Hyundai Tucson: Height adjust
Component Location
- Height adjust
Replacement
- Remove the front seat belt upper anchor.
(Refer to Front Seat Belt - "Front Seat Belt Pretensioner")
- After loosening the mounting bolts, then remove the height adjust (A).
Tightening torque : 39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)
- To install, reverse removal procedure.
WARNING
Replace any damaged clips (or pin-type retainers).
Front seat belt buckle
Component Location
- Front seat belt buckle
Replacement
- Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
- After loosening the mounting bolt, then remove the front seat belt buckle (A).
Tightening torque : 39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)
- To install, reverse removal procedure.
WARNING
Make sure the connector is plugged in properly.
READ NEXT:
Rear seat belt rectrator
Components Location
Rear seat belt rectrator RH
Rear seat belt rectrator LH
Replacement
WARNING
When installing the belt, make sure not to damage the retractor.
Remove the luggage side trim.
(Refer to Trunk Trim - "Luggage S
Rear center seat belt retractor
Components Location
Rear center seat belt retractor
Replacement
WARNING
When installing the belt, make sure not to damage the retractor.
Remove the roof trim.
(Refer to Roof Trim - "Roof Trim Assembly")
After loosening
SEE MORE:
ESC Control unit (HECU)
Components
Front - right (FR)
Rear - left (RL)
Rear - right (RR)
Front - left (FL)
MC2
MCI
ESC Control unit (HECU) connector
Bracket
ESC Control unit (HECU)- Removal
Removal
Disconnect the battery negative ( - ) terminal.
Windshield Glass - Installtion
Installtion
Using a knife, scrape the remaining sealant around the body panel
leaving about 2mm-thick sealant
(0.0079 in.) on the bonding surface. If installing a new windshield glass,
make alignment marks on
the windshield glass and th
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
