Hyundai Tucson: Rear seat belt rectrator
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Rear Seat Belt Retractor / Rear seat belt rectrator
Components Location
- Rear seat belt rectrator RH
- Rear seat belt rectrator LH
Replacement
WARNING
When installing the belt, make sure not to damage the retractor.
- Remove the luggage side trim.
(Refer to Trunk Trim - "Luggage Side Trim")
- Disconnect the rear seat belt rectrator connector (A).
LH
RH
- Loosen the mounting bolt, remove the rear seat belt rectrator (A).
Tightening torque : 39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)
LH
RH
- Install in the reverse order of removal.
WARNING
- Make sure the connector is plugged in properly.
- Replace any damaged clips (orpin-type retainers).
READ NEXT:
Rear center seat belt retractor
Components Location
Rear center seat belt retractor
Replacement
WARNING
When installing the belt, make sure not to damage the retractor.
Remove the roof trim.
(Refer to Roof Trim - "Roof Trim Assembly")
After loosening
General Information
Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components, first determine if
the malfunction is due to
the refrigerant charge, air flow or compressor.
Use the table below to help you find the cause of t
SEE MORE:
Front Radar Sensor Alignment
WARNING
Adjustment may not be accurate if the vehicle and reflector are
placed on different ground levels or on a slope.
Perform in an area with minimum clearance of 8 m to the front.
4 m wide, and 1.2 m above the ground.
Remove heavy o
Pedal Type
Front cable
Disconnect the (-) batteiy terminal.
Release the parking brake.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
Remove the Integrated Central Control Unit (ICU).
(Refer to Body Elect
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
