Hyundai Tucson: Rear center seat belt retractor
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Rear Seat Belt Retractor / Rear center seat belt retractor
Components Location
- Rear center seat belt retractor
Replacement
WARNING
When installing the belt, make sure not to damage the retractor.
- Remove the roof trim.
(Refer to Roof Trim - "Roof Trim Assembly")
- After loosening the mounting bolts, remove the rear center seat belt retractor (A).
Tightening torque : 39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)
- Install in the reverse order of removal.
WARNING
Replace any damaged clips.
Components Location
- Rear seat belt buckle LH
- Rear seat belt buckle RH
- Rear seat belt buckle CTR
Replacement
LH
- Remove the rear seat cushion assembly.
(Refer to Rear Seat -"Rear Seat Assembly")
- Disconnect the connector (A) and loosen the mounting bolt, remove the rear seat belt buckle (B).
Tightening torque : 39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)
- To install, reverse removal procedure
CTR
- Remove the rear seat back assemblyRH.
(Refer to Rear Seat -"Rear Seat Assembly")
- Loosen the mounting bolt, remove the rear seat belt buckle (A).
Tightening torque : 39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)
- To install, reverse removal procedure
RH
- Remove the rear seat cushion assembly.
(Refer to Rear Seat -"Rear Seat Assembly")
- Disconnect the connector (A) and loosen the mounting bolt, remove the rear seat belt buckle (B).
Tightening torque : 39.2 - 53.9 N.m (4.0 - 5.5 kgf.m , 28.9 - 39.8 lb-ft)
- To install, reverse removal procedure
READ NEXT:
General Information
Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components, first determine if
the malfunction is due to
the refrigerant charge, air flow or compressor.
Use the table below to help you find the cause of t
SEE MORE:
Tail Gate - Replacement
Replacement
Tailgate upper trim
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to prevent hand injuries.
Using a screwdriver or rem
DCT (Dual Clutch Transmission) System (SBC) - Removal
Removal
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
Remove the ECM.
(Refer to Engine Control / Fue
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
