TucsonDataManu

.com

Hyundai Tucson: Reclining Motor Limit Switch

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body Electrical System / Seat Electrical / Reclining Motor Limit Switch

  1. Disconnect the limit switch and operate the limit switch and then check for continuity between the terminals.
  2. Make sure that the seat operation is normal in the reverse after the maximum operation.
  3. If there is an abnormality, replace the limit switch.

Circuit

Circuit Diagram

Driver Power Seat Swtich

Passenger Power Seat Swtich

Inspection

  1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch.

Driver Power Seat Control Switch

Driver Power Seat Control Switch

  1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch.

Passenger Walk in Switch

Passenger Power Seat Control Switch

Passenger Power Seat Control Switch

Removal

Removal

  1. Disconnect the negative (-) batteiy terminal.
  2. Remove the front seat shield outer cover.

    (Refer to Body - "Front Seat Shield Outer Cover")

  3. Remove the power seat control switch (A) after loosening screws.

Installation

Installation

  1. Install the power seat control switch after connecting the connector.
  2. Install the front seat shield outer cover.
  3. Connect the negative (+) batteiy terminal.

    READ NEXT:

     Seat heater

    Components Seat heater unit Seat cushion heater Seat back heater Second line seat heater unit Second line seat cushion heater Second line seat back heater Driver/Passenger Seat Heater Components Second Line Seat Hea

     Seat  heater (Ventilation)

    Components Seat cushion heater (Ventilation) Seat heater (Ventilation) unit Seat back heater (Ventilation) Circuit Diagram Inspection Driver/Passenger Check for continuity and measure the resistance between terminals.

     Front seat heater switch / Rear seat heater switch

    Front seat heater switch Rear seat heater switch Circuit Diagram Connector Pin Information Removal When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    SEE MORE:

     Measuring the resistance of the pressure sensor- Adjustment

    Adjustment Description The friction material inside the coupling will degrade over time. Therefore, corresponding compensation values must be referenced and entered after replacing the controller or the coupling. Compensation Requirement and Pr

     Rear pillar trim

    Component Location Rear pillar trim Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries. WAR

    Information

    2022-2026 © - www.tucsondatamanu.com