TucsonDataManu

.com

Hyundai Tucson: Cylinder Head Assembly

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Mechanical System / Cylinder Head Assembly

Components

  1. Front camshaft bearing cap
  2. Intake camshaft bearing cap
  3. Exhaust camshaft bearing cap
  4. Cam carrier
  5. Fuel pump adaptor
  6. Engine hanger
  7. Cylinder head
  8. Cylinder head gasket

  1. Intake OCV center bolt
  2. Intake OCV center bolt
  3. CVVD assembly
  4. Exhaust CVVT assembly
  5. Exhaust camshaft
  6. Swing arm
  7. Hydraulic lash adjuster (HLA)
  8. Retainer lock
  9. Retainer
  10. Valve stem seal
  11. Valve spring
  12.  Valve spring seat
  13. Cylinder head
  14.  Valve

Components

  1. Cylinder head cover
  2. Engine oil filler cap
  3. Breather hose
  4. PCV hose
  5. Cylinder head cover gasket
  6. Oil seal
  7. Gasket
  8. High pressure fuel pump gasket
  9. Cam position sensor

READ NEXT:

 Cylinder Head Assembly - Removal

Disconnect the battery negative terminal. Remove the engine cover. (Refer to Engine and Transaxle Assembly - "Engine Cover") Remove the air duct and air cleaner assembly. (Refer to Intake and Exhaust System - "Air Cleane

 Cylinder Head Assembly- Installation

The hardening sealant located on the upper area between timing chain cover and cam carrier, cylinder head cover should be removed before assembling cylinder head cover. Install the cylinder head cover. (1) Install the new gasket. WARNIN

 Cylinder head cover

Removal Disconnect the battery negative terminal. Remove the cylinder head cover. (Refer to Cylinder Head Assembly - "Cylinder Head Cover") Turn the crankshaft damper pulley so that No. 1 piston is at top dead center. (1)

SEE MORE:

 Cylinder Block - Removal and Installation

Remove the cylinder head. (Refer to Cylinder Head Assembly - "Cylinder Head") Remove the RH water jacket insert and LH water jacket insert (A). WARNING When removing the water jacket insert, Be careful not to damage the

 Gear actuator assembly- Installation

To install, reverse the removal procedure. WARNING Check the details below before installing the gear acmator assembly. 1)Check that the gear acmator is placed in the "neutral" state. 2)Check the assembled state of the O-ri

Information