Hyundai Tucson: Rear seat back cover - LH

Component Location

1. Rear seat back cover LH
2. Rear seat back cover RH

Replacement

WARNING

Put on gloves to protect your hands.

WARNING

Take care not to bend or scratch the rear seat assembly.

LH

1. Remove the rear seat back assembly LH.

   (Refer to Rear Seat - "Rear Seat Assembly")

2. Loosen the mounting screw, remove the rear seat slide knob (A).

3. Loosen the mounting screws, press the lock pin (B) and remove the rear seat shield outer cover (A).

4. Loosen the mounting screws, remove the rear seat shield inner cover (A).

5. Press the lock pin and remove the rear seat headrest (A).

6. Remove the headrest guides (A) by pulling upward.

7. Open the cover, loosen the mounting screw and remove the rear seat back webbing guide (A).

8. Remove the child anchor cover (A).

9. Remove the rear seat back protector (A).

10. Remove the rear seat back cover (A).

11. Remove the hog-ring clips (A).

12. Remove the rear seat back cover (A) from the rear seat frame.

13. After removing the Velcro tape (A) and tie down clips (B) inside the rear seat cushion cover, remove the seat cushion cover (C).

WARNING

Be careful not to deviate from the pads, insert wires, and aplix.

14. To install, reverse the removal procedure.

WARNING

• To prevent wrinkles, make sure that the cover (B) is stretched evenly before connecting the hog-ring clips (A).
• Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

READ NEXT: