Hyundai Tucson: Driveshaft and axle
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Driveshaft and axle
- Front Axle Assembly
- Driveshaft Assembly
- Rear Axle Assembly
- Rear Driveshaft Assembly
- Propeller Shaft Assembly
- Differential Carrier Assembly
READ NEXT:
Front Axle Assembly
Components
Front brake disc
Front hub assembly
Dust cover
Front knuckle
Removal
WARNING
When lifting a vehicle using a lift, be careful not to damage
the lower parts of the vehicle (floor under cover,
fuel filter, fuel tank
Driveshaft Assembly- Removal
Components
Front driveshaft (LH)
Inner shaft bearing bracket
Front driveshaft (RH)
Removal
WARNING
When lifting a vehicle using a lift, be careful not to damage
the lower parts of the vehicle (floor under cover,
fuel filter,
SEE MORE:
Rear seat back cover - CTR
Remove the rear seat back assembly RH.
(Refer to Rear Seat - "Rear Seat Assembly")
Loosen the mounting screws, remove the rear seat shield inner cover (A).
Press the lock pin and remove the rear seat headrest (A).
Battery Module Inlet Duct
Turn ignition switch OFF and disconnect the battery (-) terminal.
Remove the 48V battery assembly
(Refer to 48V Battery System - "Repair procedures")
Remove the battery cover (A) after loosening the mounting bolts.
Tightening
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
