TucsonDataManu

.com

Hyundai Tucson: Rear Driveshaft Assembly

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Driveshaft and axle / Rear Driveshaft Assembly

READ NEXT:

 Rear Driveshaft Assembly- Removal

Components Rear drive shaft Removal WARNING When lifting a vehicle using a lift, be careful not to damage the lower parts of the vehicle (floor under cover, fuel filter, fuel tank, canister). (Refer to General Information - "L

 Rear Driveshaft Assembly - Disassembly

Disassembly WARNING Do not disassemble the BJ assembly. Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease. The boot band should be replaced with a new one. Remove the TJ boot bands

 Propeller Shaft Assembly

Components Front propeller shaft Center bearing bracket Rear propeller shaft Removal WARNING When lifting a vehicle using a lift, be careful not to damage the lower parts of the vehicle (floor under cover, fuel filter, fuel tank,

SEE MORE:

  Concentric Slave Cylinder Assembly- Adjustment

Gasoline 1.6 T-GDI Turn ignition switch OFF and disconnect the negative (-) battery cable. Remove the air cleaner assembly and air duct. (Refer to In case by Gasoline 1.6 T-GDI System - "Air Cleaner") After disconnecting a cap

 Timing System - Replacement

Components Variable force solenoid valves Timing chain cover Cam to cam guide Timing chain Timing chain tensioner arm Timing chain tensioner arm Timing chain tensioner Crankshaft sprocket Oil pump chain Oil pump chain tensio

Information