Hyundai Tucson: Rear bumper beam assembly
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Rear Bumper / Rear bumper beam assembly
Component Location
- Rear bumper beam assembly
Replacement
WARNING
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- Put on gloves to prevent hand injuries.
WARNING
Take care not to bend or scratch the bumper cover and panels.
- Remove the rear bumper assembly.
(Refer to Rear Bumper - "Rear Bumper Assembly")
- Disconnect the antenna connector (A) and loosen the mounting clips, remove the rear bumper beam assembly (B).
- To install, reverse removal procedure.
WARNING
- Make sure the connector is plugged in properly.
- Replace any damaged clips (or pin-type retainers).
READ NEXT:
Front seat assembly
Component Location
Front seat assembly
Replacement
Disconnect the negative (-) battery terminal.
Open the cover and loosen the front seat mounting bolts.
Front
Tightening torque :
49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb
Front seat shield outer cover
Component Location
Front seat shield outer cover
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to prevent hand inj
SEE MORE:
Button Engine Start System
Description
The System offers the following features :
Changing the state of engine ignition and power by using the start
button.
Controlling external relays for ACC / IGN1 / IGN2 terminal switching and
STARTER, without use of mechanical
Engine Oil - Removal and Installation
Disconnect the battery negative terminal.
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
Drain the coolant.
(Refer to Cooling System - "Coolant")
D
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
