TucsonDataManu

.com

Hyundai Tucson: Front seat shield outer cover

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Front Seat / Front seat shield outer cover

Component Location

  1. Front seat shield outer cover

Replacement

WARNING

  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Put on gloves to prevent hand injuries.

WARNING

Take care not to bend or scratch the trim and panels.

  1. Remove the front seat assembly.

    (Refer to Front Seat - "Front Seat Assembly")

  2. Remove the front seat outer shield cover.

(1) Separate the clip (C) and hook (D).

(2) Press the lock pin (B), remove the front seat outer shield cover (A) by pulling it forward as shown by the arrow.

  1. Disconnect the front seat power swich connector (A).

  1. To install, reverse removal procedure.

WARNING

  • Make sure the connector is plugged in properly.
  • Replace any damaged clips (or pin-type retainers).

    READ NEXT:

     Front seat shield inner cover/ Front seat back cover

    Component Location Front seat shield inner cover Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand inj

     Front seat cushion cover

    Component Location Front seat cushion cover Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries

     Rear Seat

    SEE MORE:

     IMT System Actuator- Installation

    Installation Install the IMT system actuator (A) and then tightening the bolts. Tightening torque: 19.6 - 26.5 N.m (2.0 - 2.7 kgf.m. 14.5 - 19.5 lb-ft) Lightly install the concentric slave cylinder (B) on the input shaft (A).

     Glass step alignment

    Alignment Perform considerable step alignment after replacing movable glass (A). Perfrom height adjustment releasing screw (A) a bit. WARNING Be careful not to damage screws. Remove the decoration cover (A).

    Information

    2022-2026 © - www.tucsondatamanu.com