TucsonDataManu

.com

Hyundai Tucson: Front seat shield inner cover/ Front seat back cover

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Front Seat / Front seat shield inner cover/ Front seat back cover

Component Location

  1. Front seat shield inner cover

Replacement

WARNING

  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Put on gloves to prevent hand injuries.
  1. Remove the front seat assembly.

    (Refer to Front Seat - "Front Seat Assembly")

  2. Loosen the mounting screw, remove the front seat shield inner cover (A).

  1. To install, reverse removal procedure.

WARNING

Replace any damaged clips (or pin-type retainers).

Front seat back cover

Component Location

  1. Front seat back cover

Replacement

WARNING

  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Put on gloves to prevent hand injuries.

WARNING

Take care not to bend or scratch the front seat.

  1. Remove the front seat shield outer cover.

    (Refer to Front Seat - "Front Seat Outer Shield Cover")

  2. Remove the front seat shield inner cover.

    (Refer to Front Seat - "Front Seat Inner Shield Cover")

  3. Press the lock pin, remove the front seat headrest (A).

  1. Remove the front seat lower protector (A).

  1. Remove the front seat back board (A).

WARNING

  • Grasp the both lower sides of back board with hands and then remove it in the direction of the arrow.
  • Be careful not to damage the fixing clips.

  1. Remove the front seat back duct (A).

  1. Press the hook (B), remove the headrest guides (A) and cover (C).

  1. Disconnect the connector (A).

  1. Remove the protector (A) from the front seat back frame.

Upper

Lower

Lower

LH

LH

RH

RH

WARNING

WARNING

In the case of a passenger seat, remove the walk in switch (A) and remove the seat back cover.

  1. After removing the Velcro tape (A) and tie-down clips (B) inside the front seat back cover, remove the seat back cover (C).
  1. To install, reverse removal procedure.

WARNING

  • Make sure that the connectors are connected completely
  • Replace any damaged clips (or pin-type retainers).

    READ NEXT:

     Front seat cushion cover

    Component Location Front seat cushion cover Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries

     Rear Seat

     Front seat cushion cover / Rear seat back assembly

    Component Location Rear seat cushion assembly Rear seat back assembly Replacement Rear seat cushion assembly Remove the rear seat cushion assembly (A). Press the lock pin, separate the connectors (A). To inst

    SEE MORE:

     GPF (Gasoline Particulate Filter)

    Turn the ignition switch OFF and disconnect the battery negative (-) cable. Remove the floor under cover front RH. Disconnect the Exhaust Gas Temperature Sensor (EGTS) Front (A) and Rear (B). Remove the gasoline particulate fil

     Interior lights

    WARNING Do not use the interior lights when driving in the dark. The interior lights may obscure your view and cause an accident. NOTICE Do not use the interior lights for extended periods when the vehicle is turned off or the battery will di

    Information

    2022-2026 © - www.tucsondatamanu.com