Hyundai Tucson: Front seat cushion cover
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Front Seat / Front seat cushion cover
Component Location
- Front seat cushion cover
Replacement
WARNING
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- Put on gloves to prevent hand injuries.
WARNING
Take care not to bend or scratch the front seat.
- Remove the front seat shield outer cover.
(Refer to Front Seat - "Front Seat Outer Cover")
- Remove the front seat shield inner cover.
(Refer to Front Seat - "Front Seat Inner Cover")
- Remove the front seat lower protector (A).
- Disconnect the connectors (A).
- Remove the protector (A) from the front seat cushion frame.
Upper
Lower
LH
RH
- After removing the Velcro tape (A) inside the front seat cushion cover,
remove the seat cushion
cover (B).
- To install, reverse removal procedure.
WARNING
- Make sure that the connectors are connected completely
- Replace any damaged clips (or pin-type retainers).
READ NEXT:
Front seat cushion cover / Rear seat back assembly
Component Location
Rear seat cushion assembly
Rear seat back assembly
Replacement
Rear seat cushion assembly
Remove the rear seat cushion assembly (A).
Press the lock pin, separate the connectors (A).
To inst
Rear seat back cover - LH
Component Location
Rear seat back cover LH
Rear seat back cover RH
Replacement
WARNING
Put on gloves to protect your hands.
WARNING
Take care not to bend or scratch the rear seat assembly.
LH
Remove the rear seat back assembly L
SEE MORE:
System operation
Ventilation
Set the mode to the
position.
Set the air intake control to the
outside (fresh) air position.
Set the temperature control to the
desired position.
Set the fan speed control to the
desired speed.
Heating
Warning Lamp
Activation
Warning Lamp Behavior after Ignition On
As soon as the operating voltage is applied to the SRSCM ignition input, the
SRSCM activates the
warning lamp for a LED lamp check.
The lamp shall turn on for 6 seconds during the initialization phase an
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
