TucsonDataManu

.com

Hyundai Tucson: Front seat cushion cover / Rear seat back assembly

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Rear Seat / Front seat cushion cover / Rear seat back assembly

Component Location

Rear seat cushion assembly
Rear seat back assembly

Replacement

Rear seat cushion assembly

Remove the rear seat cushion assembly (A).

Press the lock pin, separate the connectors (A).

To install, reverse the removal procedure.

Rear seat back assembly

Disconnect the negative (-) battery terminal.
Remove the rear seat cushion assembly.
Remove the luggage board (A).

Remove the luggage tray (A).

Open the folding cable cover (A).

Separate the folding cable cover (A).

Separate the rear seat folding cable (A).

Remove the rear seak back assembly.

(1) Disconnect the connector (A).

(2) Loosen the mounting bolts, remove the rear seat back assembly (A).

Tightening torque : 49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb-ft)

(3) Disconnect the connector (A).

(4) Loosen the mounting bolts, remove the rear seat back assembly (A).

Tightening torque : 49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb-ft)

To install, reverse the removal procedure.

WARNING

Make sure the connector Is connected in properly.

Rear seat back cover - LH

Component Location Rear seat back cover LH Rear seat back cover RH Replacement WARNING Put on gloves to protect your hands. WARNING Take care not to bend or scratch the rear seat assembly. LH Remove the rear seat back assembly L

Rear seat back cover - RH

Remove the rear seat back assembly RH, (Refer to Rear Seat - "Rear Seat Assembly") Loosen the mounting screw, remove the rear seat slide knob (A). Loosen the mounting screws, press the lock pin (B) and remove the rear se

Rear seat back cover - CTR

Remove the rear seat back assembly RH. (Refer to Rear Seat - "Rear Seat Assembly") Loosen the mounting screws, remove the rear seat shield inner cover (A). Press the lock pin and remove the rear seat headrest (A).

SEE MORE:

Fuel pump service

Inspection Turn the ignition switch OFF and disconnect the battery (-) terminal. Remove the fuel pump assembly. (Refer to - "Removal" Procesures) Using an ohmmeter, measure the resistance between terminals 1 and 6 of sender

Smart Cruise Control Operation

Operating conditions Smart Cruise Control will operate when the following conditions are satisfied. Basic function The gear is in D (Drive) The driver's door is closed EPB (Electronic Parking Brake) is not applied Your vehicle speed is within