TucsonDataManu

.com

Hyundai Tucson: Engine Oil - Removal and Installation

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Mechanical System / Lubrication System / Engine Oil - Removal and Installation

  1. Disconnect the battery negative terminal.
  2.  Remove the engine room under cover.

(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")

  1. Drain the coolant.

(Refer to Cooling System - "Coolant")

  1. Drain the engine oil.

(Refer to Lubrication System - "Engine Oil")

  1. Disconnect the oil pressure temperature sensor connector (A).

  1. Disconnect the oil cooler hoses (A).

  1. Remove the oil filter & cooler assembly (A).

Tightening torque : 22.6 - 27.5 N.m (2.3 - 2.8 kgf.m, 16.6 - 20.3 lb-ft)

  1. Install the other parts in the reverse order of removal.
  2. Refill with the engine oil.

(Refer to Lubrication System - "Engine Oil")

  1. Fill the radiator with coolant.

(Refer to Cooling System - "Coolant")

WARNING

The coolant must be injected according to the integrated thermal management module (ITM) coolant filling method.

    READ NEXT:

     Oil Pump

     Removal and Installation Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") Drain the engine oil. (Refer to Lubrication System - "Engine Oil") Remove t

     Oil Pump Chain

    Disconnect the battery negative terminal. Remove the timing chain. (Refer to Timing System - "Timing Chain") Remove the oil pump chain tensioner (A). Tightening torque : 9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

      Repair procedures

    Compession Pressure Inspection WARNING If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. Start the engine and turn the coolant temperature to 80 - 95 ºC and stop. Remove the

    SEE MORE:

     Front Axle Assembly

    Components Front brake disc Front hub assembly Dust cover Front knuckle Removal WARNING When lifting a vehicle using a lift, be careful not to damage the lower parts of the vehicle (floor under cover, fuel filter, fuel tank

     Heater unit assembly

    Component Location Heater unit assembly Components Heater unit assembly Heater core cover Heater core assembly Mode control actuator LH DEF duct seal Evaporator assembly Flange seal Heater NVH pad Temperature contro

    Information

    2022-2026 © - www.tucsondatamanu.com