Hyundai Tucson: Rear Bumper
Components
- Rear bumper assembly
- Rear bumper under cover C'TR
- Rear bumper side under cover RH
- Rear bumper side bracket RH
- Rear bumper side bracket LH
READ NEXT:
Rear bumper assembly
Component Location
Rear bumper assembly
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to prevent
damage to components.
Put on gloves to prevent hand injuries.
Rear bumper beam assembly
Component
Location
Rear bumper beam assembly
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to prevent hand injuri
SEE MORE:
IMT System Actuator- Installation
Installation
Install the IMT system actuator (A) and then tightening the bolts.
Tightening torque:
19.6 - 26.5 N.m (2.0 - 2.7 kgf.m. 14.5 - 19.5 lb-ft)
Lightly install the concentric slave cylinder (B) on the input shaft
(A).
Brake Booster - Removal
Components
Reservoir cap
Reservoir
Brake booster
Master cylinder
Push rod
Removal
Turm ignition switch OFF and disconnect the negative (-) battery cable.
Remove the battery.
(Refer to Engine Electrical System - "Batter
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
