Hyundai Tucson: Front Bumper - Replacement
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper - Replacement
Components
- Front bumper assembly
- Front bumper side bracket
Component Location
- Front bumper assembly
Replacement
WARNING
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- Put on gloves to prevent hand injuries.
WARNING
Take care not to bend or scratch the bumper cover and panels.
- Disconnect the negative (-) battery terminal.
- Remove the engine room under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
- Remove the fender garnish (A).
- Loosen the front bumper upper mounting clips.
- Loosen the mounting clis and screws on the side of front bumper (A), detach the side part of front bumper.
WARNING
When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.
- Disconnect the front bumper main connector (A).
- Remove the front bumper assembly (A).
- To install, reverse removal procedure.
WARNING
- Make sure the connector is plugged in properly.
- Replace any damaged clips (or pin-type retainers).
READ NEXT:
Radiator grill
Component Location
Radiator grill
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to prevent hand injuries.
WARNI
Rear Bumper
Components
Rear bumper assembly
Rear bumper under cover C'TR
Rear bumper side under cover RH
Rear bumper side bracket RH
Rear bumper side bracket LH
Rear bumper assembly
Component Location
Rear bumper assembly
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to prevent
damage to components.
Put on gloves to prevent hand injuries.
SEE MORE:
Climate control additional features
Auto Defogging System on Models with Automatic Temperature Control
Auto defogging helps reduce the
possibility of fogging up the inside of the
windshield by automatically sensing the
moisture on inside the windshield.
The auto defogging sy
Rear Driveshaft Assembly - Disassembly
Disassembly
WARNING
Do not disassemble the BJ assembly.
Special grease must be applied to the driveshaft joint. Do not
substitute with another type of grease.
The boot band should be replaced with a new one.
Remove the TJ boot bands
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
