TucsonDataManu

.com

Hyundai Tucson: Rear door trim - Removal

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Rear Door / Rear door trim - Removal

  1. Remove the rear door trim.

    (Refer to Rear Door - "Rear Door Trim")

  2. After loosening the mounting screws, remove the rear door inside handle (A).

  1. To install, reverse removal procedure.

WARNING

Make sure the door locks / unlocks and opens / closes properly.

Installation

  1. Install the rear door inside handle.
  2. A screw is attached to the cut heat-welded portion.

WARNING

Because there is no groove to attach the screw to the heat weld, install the screwdriver in a straight line.

WARNING

WARNING

When replacing the rear door inside handle, tighten it by using the M5-8mm screw.

    READ NEXT:

     Rear door window glass

    Component Location Rear door window glass Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries.

     Rear door outside handle

    Component Location Rear door outside handle Replacement Rear Door Outside Handle Assembly WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put

     Rear Door Trim - Replacement

    Pull down the rear door window glass to the lowest level by pressing the power window glass switch. Remove the rear door belt outside weatherstrip (A). To install, reverse the removal procedure. WARNING Replace any damaged cli

    SEE MORE:

     Windshield defrosting and defogging

    WARNING Windshield heating Do not use the position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to f

     Measuring the resistance of the pressure sensor- Adjustment

    Adjustment Description The friction material inside the coupling will degrade over time. Therefore, corresponding compensation values must be referenced and entered after replacing the controller or the coupling. Compensation Requirement and Pr

    Information