TucsonDataManu

.com

Hyundai Tucson: Rear door window glass

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Rear Door / Rear door window glass

Component Location

  1. Rear door window glass

Replacement

WARNING

  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Put on gloves to prevent hand injuries.
  1. Remove the rear door trim.

    (Refer to Rear Door - "Rear Door Trim")

  2. Remove the rear door belt inside weatherstrip.

    (Refer to Rear Door - "Rear Door Belt Inside Weatherstrip")

  3. Remove the rear door belt outside weatherstrip.

    (Refer to Rear Door - "Rear Door Belt Outside Weatherstrip")

  4. Loosen the mouting screw, remove the rear door frame garnish LH (A).

  1. Loosen the rear door channel mounting bolt and nuts.

Tightening torque :

Bolt: 6.9 - 10.8 N.m (0.7 - l.lkgf.m, 5.1 - 8.0 lb-ft)

Nut: 3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

  1. Pull down rear door window glass by pressing the power window glass switch.

WARNING

Be careful not to drop the glass and/or scratch the glass surface.

  1. Carefully adjust the rear door window glass (A) until the bolts are visible, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

Tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

  1. To install, reverse the removal procedure.

WARNING

  • Make sure that the glass rolls up and down smoothly.
  • Adjust glass position as needed.
  • Make sure the door locks and opens properly.
  • Replace any damaged clips (orpin-type retainers).

    READ NEXT:

     Rear door outside handle

    Component Location Rear door outside handle Replacement Rear Door Outside Handle Assembly WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put

     Rear Door Trim - Replacement

    Pull down the rear door window glass to the lowest level by pressing the power window glass switch. Remove the rear door belt outside weatherstrip (A). To install, reverse the removal procedure. WARNING Replace any damaged cli

     Rear door latch

    Component Location Rear door latch Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries. R

    SEE MORE:

     Liftgate

    Opening the liftgate Make sure the vehicle is in P (Park) and set the parking brake. Then do one of the following: Unlock all doors with the Door Unlock button on your remote key or smart key. Press the liftgate handle button and o

      Exhaust Emission Control System - Description

    Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine modifications and the addition of special control components. Modifications to the combustion chamber, intake manifold, camshaft and ignition system consist the basic

    Information

    2022-2026 © - www.tucsondatamanu.com