TucsonDataManu

.com

Hyundai Tucson: Air Cleaner Assembly

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Mechanical System / Intake And Exhaust System / Air Cleaner Assembly

Removal and Installation

  1. Disconnect the battery negative terminal.
  2. Disconnect the air flow sensor (AFS) connector (A).

  1. Remove the air duct (A).

  1. Disconnect the RCV hose (A).

  1. Remove the air cleaner assembly

Tightening torque : Intake hose clamp : 2.9 - 4.9 N.m (0.3 - 0.5 kgf.m, 2.2 - 3.6 lb-ft)

Air cleaner assembly :8.0 - 10.0 N.m (0.8 - 1.0 kgf.m, 6.0 - 7.4 Ib-ft)

(1) Remove the breathe hose (A).

(2) Remove the intake hose (B).

(3) Remove the air cleaner assembly (C).

  1. Install in the reverse order of removal.

    READ NEXT:

     Air Cleaner Element Replacement

    Open the air cleaner element cover (A) by lifting up the air cleaner element cover handle. Unlock the air cleaner element camshaft (A) by turning in the direction of arrow. Replace the air cleaner element (A) with a new o

     Catalytic converter - Components

    Warm up catalytic converter Warm up catalytic converter gasket Warm up catalytic converter upper stay bracket Warm up catalytic converter lower stay bracket Cylinder head heat peotector Oil feed pipe Torbo charhe water outlet hose

     Intake And Exhaust System

    Removal and Installation Remove the Turbocharger & Exhaust Manifold. (Refer to Intake And Exhaust System - "Exhaust Manifold") On-vehicle Inspection Turbocharger Diagnostic Flow If any problem related with turbocharger,

    SEE MORE:

     Wireless power charging

    Components Wireless power charging unit Wireless power charging lamp Troubleshooting Wireless Power Charger System Troubleshooting R-l. Check the wireless power charger system operation If the placement of a mobile phone is not

     Transmission Control Module (TCM) Inspection Procedure

    Inspecting TCM ground circuit: Measure the resistance between the TCM and chassis ground. (Check the terminal connected to the chassis ground while using the back of the harness connector as the base point for TCM.) Normal reading (re

    Information