Hyundai Tucson: Intake And Exhaust System
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Engine Mechanical System / Intake And Exhaust System
- Air Cleaner Assembly
- Air Cleaner Element Replacement
- Catalytic converter - Components
- Intake And Exhaust System
- EGR cooler
- EGR cooler- Removal and Installation
- Front Muffler
- GPF (Gasoline Particulate Filter)
READ NEXT:
Air Cleaner Assembly
Removal and
Installation
Disconnect the battery negative terminal.
Disconnect the air flow sensor (AFS) connector (A).
Remove the air duct (A).
Disconnect the RCV hose (A).
Remove the air cleaner assembly
Tight
Air Cleaner Element Replacement
Open the air cleaner element cover (A) by lifting up the air cleaner
element cover handle.
Unlock the air cleaner element camshaft (A) by turning in the direction
of arrow.
Replace the air cleaner element (A) with a new o
Catalytic converter - Components
Warm up catalytic converter
Warm up catalytic converter gasket
Warm up catalytic converter upper stay bracket
Warm up catalytic converter lower stay bracket
Cylinder head heat peotector
Oil feed pipe
Torbo charhe water outlet hose
SEE MORE:
High Pressure Fuel Line- Installation
Install in the reverse order of removal.
Install the high pressure fuel pipe as follows.
(1) Completely pre-tighten the both side nuts (A) on high pressure tightening
area of high pressure fuel pipe
while keeping them vertically.
(2) Ti
Rear center seat belt retractor
Components Location
Rear center seat belt retractor
Replacement
WARNING
When installing the belt, make sure not to damage the retractor.
Remove the roof trim.
(Refer to Roof Trim - "Roof Trim Assembly")
After loosening
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
