Hyundai Tucson: Pressure Side Impact Sensor (P-SIS)

1. Disconnect the batteiy negative terminal.

WARNING

After disconnecting the cables, wait at least 3 minutes.

2. Remove the front door trim.

   (Refer to Body - "Front Door Trim")

3. Disconnect the connector (A) from the pressure side impact sensor.

4. Remove the pressure side impact sensor (A) after rotating it 90º in a counterclockwise direction.

Gravity Side Impact Sensor (G-SIS) _ B pillar

1. Disconnect the batteiy negative terminal.

WARNING

After disconnecting the cables, wait at least 3 minutes.

2. Remove the center pillar lower trim.

   (Refer to Body - "Center Pillar Trim")

3. Remove the gravity side impact sensor (A) by removing the mounting bolt and then disconnecting the connector (B).

Tightening torque : 10.8 - 12.8 N m (1.1-1.3 kgf m, 8.0 - 9.4 lbf ft)

Gravity Side Impact Sensor (G-SIS) _ C pillar

1. Disconnect the batteiy negative terminal.

WARNING

After disconnecting the cables, wait at least 3 minutes.

2. Remove the luggage side trim.

   (Refer to Body - "Luggage Side Trim")

3. Remove the rear side impact sensor (A) by removing the mounting bolt and then disconnecting the connector (B).

Tightening torque : 10.8 - 12.8 N m (1.1-1.3 kgf m, 8.0 - 9.4 lbf ft)

Installation

WARNING

Do not turn the ignition switch ON and do not connect the batteiy cable while replacing the side impact sensor.

1. Install in the reverse of the removal.
2. After installing the SIS, confirm proper system operation:

WARNING

Switch ON the ignition. The SRS indicator light should turn on for about three-six seconds and then off.

Description

• Driver can control the passenger airbag operating Condition (Enable or Disable) by using this PAB ON/OFF switch.
• Passenger Airbag (PAB) ON/OFF Switch is installed in the crash pad side cover.

READ NEXT: