TucsonDataManu

.com

Hyundai Tucson: SRSCM

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Restraint / SRSCM

Components Location

Supplemental Restraint System Control Module (SRSC'M)
Gravity Side Impact Sensor (G-SIS) _ C pillar
Gravity Side Impact Sensor (G-SIS) _ B pillar
Front Impact Sensor (FIS) RH
Front Impact Sensor (FIS) LH
Pressure Side Impact Sensor (P-SIS)

Description

The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not.

The SRSCM must decide whether to deploy the restraint system or not. After determining that pretensioners and/or airbag deployment is required, the SRSCM must supply sufficient power to the pretensioners and airbag igniters to initiate deployment.The SRSCM determines that an impact may require deployment of the pretensioners and airbags from data obtained from impact sensors and other components in conjunction with a safing function.

The SRSCM will not be ready to detect a crash or to activate the restraint system devices until the signals in the SRSCM circuitry is stabilized. It is possible that the SRSCM could activate the safety restraint devices in approximately 2 seconds but is guaranteed to fully function after prove-out is completed.

The SRSCM must perform a diagnostic routine and light a system readiness indicator when the ignition switch is in the ON position. The system must perform a continuous diagnostic routine and provide fault notice through a warning lamp indicator in the event of fault detection. A serial diagnostic communication interface will be used to facilitate servicing of the restraint control system.

Supplemental Restraint System Control Module (SRSCM)

Components Location Supplemental Restraint System Control Module (SRSCM) Supplemental Restraint System Control Module (SRSCM) Removal Disconnect the battery negative terminal. WARNING After disconnecting the cables

SRSCM - Installation

Installation Install in the reverse of the removal. After installing the SRSCM, confirm proper system operation. WARNING SIf the Switch ON the ignition, the SRS indicator light should turn on for about six seconds and then off. Variant

Pressure Side Impact Sensor (P-SIS)

Disconnect the batteiy negative terminal. WARNING After disconnecting the cables, wait at least 3 minutes. Remove the front door trim. (Refer to Body - "Front Door Trim") Disconnect the connector (A) from the pressure side im

SEE MORE:

Engine Mechanical System

Components Pulley Stator assembly Rotor assembly Brush holder assembly Front bracket assembly Rear bracket assembly Inverter assembly Removal Turn the ignition switch OFF and disconnect the battery (-) terminal. Disconnec

CCWD Actuator- Installation

WARNING When installing the CVVD actuator the shaft gear do not fit properly, rotate the C W D actuator in both directions and installing it uaturally. (Do not impact when installating the component.) Do not damage to the component whe