TucsonDataManu

.com

Hyundai Tucson: PAB ON/OFF Switch

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Restraint / SRSCM / PAB ON/OFF Switch

Components Location

  1. PAB ON/OFF Switch

Removal

  1. Disconnect the battery negative terminal.

WARNING

After disconnecting the cables, wait at least 3 minutes.

  1. Remove the crash pad side cover.

    (Refer to Body - "Crash Pad Side Cover")

  2. Press the lock pin, separate the passenger air bag ON/OFF switch connector (A).
  3. Remove the PAB ON/OFF switch (B).

Installation

Installation

WARNING

Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.

  1. Install in the reverse of the removal.
  2. After installing the PAB ON/OFF Switch, confirm proper system operation:

WARNING

Switch ON the ignition. The SRS indicator light should turn on for about three-six seconds and then off.

    READ NEXT:

     Airbag Module

     Airbag Module- Description

    Driver Air Bag (DAB) DAB is installed in the steering wheel, and electrically connected to the SRSCM via clock spring. It is deployed during frontal impact to protect the driver. Clock Spring Clock spring delivers actuation signal, ge

     Airbag Module - Removal

    Removal Set the front tires straight-ahead. Disconnect the batteiy negative terminal. WARNING After disconnecting the cables, wait at least 3 minutes. Put a flat tool (05mm) into a guide hole located in the left/right of steering whe

    SEE MORE:

     Rear Wiper Washer - Removal

    Disconnect the negative (-) battery terminal. Loosen the mounting nut and remove the rear wiper arm & blade (A). WARNING Take care not to damage the rear glass when removing the rear wiper arms & blades. Remove the tail gat

     When Ignition Key Is Turned ON (engine OFF), The ABS Warning Lamp Does Not Light Up.

    Detecting condition When current flows in the HECU the ABS warning lamp turns from ON to OFF as the initial check. Therefore if the lamp does not light up. the cause may be an open in the lamp power supply circuit, a blown bulb, an open in the bo

    Information